Pro 4: ANC / Transparency Mode not working with LE Audio

May 10,2025
Spyro
May 10,2025 at 3:47 pm
May 10,2025 at 3:47 pm

Hi there, 

after an Android Update, a few restart and reinstalling earfun, deleting and repairing the device on my Pixel 8, I was finally able to activate LE Audio :) 

But now I can't use ANC and transpareny mode anymore. They are just reseting themselves to "normal' after activation... 

Will there be a fix? 

 

Report Reply
EarFun CS Team

Staff Member

May 12,2025 at 6:19 am
May 12,2025 at 6:19 am

If you're experiencing issues switching between noise cancellation modes, it could be due to the following reasons:

① The earphones remain in normal mode if they haven't been taken out of the charging case.

② Accidental touches on the touch control area may have caused unexpected mode changes. You can try disabling the touch control feature in the EarFun Audio App to see if the issue is related to accidental touches.

③ In-ear detection is enabled, but the earbuds are not being worn. In this case, the earbuds will stay in normal mode. They should automatically switch back to the mode you used during your last session once you put them in your ears.

Report #1 Reply
Spyro
May 24,2025 at 1:34 pm
May 24,2025 at 1:34 pm

Hi again, thank you. The auto-reset was indeed caused by the ear-detection.

BTW: After some more restart, the earphones just disconnect and are not able to connect again unless LE Audio is deactivated again. 

Report #2 Reply

Thread Info

0 Likes

2 Replies

3 Views

Last replied by Spyro

Community Highlight

About the IDEAS & SUGGESTIONS category About the IDEAS & SUGGESTIONS category

by EarFun Admin Jan 04,2022

Forum Statistics

945 Discussions

1621 Messages

2868 Members

Share this thread